Installation instructions
en
55
22.2 Planning notes
Observe the following planning notes before installing
the appliance.
¡
The door direction cannot be reversed.
¡
The distance from the cabinet cavity to the door
panel surface is 21 mm.
¡
The distance from the cabinet cavity to the outer
edge of the door handle is 72 mm.
¡
Note the front projection, including the door handle,
for opening drawers next to the appliance.
¡
When planning a corner solution, consider a door
opening angle of at least 110°.
¡
Do not install any other electrical appliance in the
cupboard above this appliance.
¡
This appliance is intended for front flush installation.
Even with a minor protrusion of the cabinet panel
above the appliance, there is a risk of damage to
the cabinet by escaping steam.
22.3 Appliance dimensions
You will find the dimensions of the appliance here
22.4 Position of connections
Here, you can find the position of the connections on
the appliance.
22.5 Preparing the units
Requirement:
Fitted units must be heat-resistant up to
90 °C, and adjacent unit fronts up to 70 °C.
1.
Ensure that the mains socket is located outside of
the built-in niche.
2.
Carry out cut-out work on the units and then insert
the appliance.
3.
After making the cut-outs, remove any shavings.
Shavings may impair the function of electrical com-
ponents.
4.
Secure any unsecured units to the wall using a
standard bracket.
5.
Only install the appliance high enough that the cus-
tomer can remove the accessory effortlessly.
22.6 Electrical connection
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
¡
The appliance corresponds to protection class I and
must only be operated with a protective earth con-
nection.
¡
The fuse protection must correspond to the power
rating specified on the appliance's rating plate and
to the local regulations.
¡
The appliance must be disconnected from the
power supply whenever installation work is being
carried out.
¡
The appliance must only be connected using the
power cable provided. Plug the power cable fully
into the back of the appliance.
¡
The power cable must only be replaced with a cable
from the original manufacturer. The power cable can
be obtained from customer service.
¡
Contact protection must be guaranteed by the in-
stallation.
Power cable with a plug with earthing contact
For an appliance with a plug with earthing contact, fol-
low these instructions.
¡
Connect the appliance only to a correctly installed,
earthed socket.
¡
If the plug with earthing contact can no longer be
accessed after installation, an energy-isolating
device in the phases must be provided in the per-
manent electrical installation in accordance with the
installation regulations.
22.7 LAN connection to the home network
This appliance can be networked. You can connect the
appliance to the home network using a LAN cable. The
scope of delivery does not include a LAN cable.
Establishing the LAN connection
1.
Before installing the appliance, insert a LAN cable
into the socket on the back of the appliance.
2.
Use the strain relief to secure the LAN cable in
place.
3.
Connect the LAN cable to a network connection.
