81
2. Operating System and Equipment
High beam lamp
-
Turn the ignition switch or start switch to
"ON" position.
-
Turn the switch to the low beam position.
-
Pushing the light combination switch
lever forward to its limit position turns on
high beams, and the indicator light
is lit on the combination instrument ac-
cordingly.
-
Pull the light combination switch lever
backward to its original position to turn
off the high beams.
Warning
High beams of the headlamps may dazzle
the drivers of other vehicles nearby, re
-
sulting in accidents.
Headlamp flasher
-
Turn the ignition switch or start switch to
"ON" position.
-
Pulling the light combination switch le-
ver to Position -3 turns on the headlight
flasher.
Warning
Even if there isn't vehicle light turned on,
as long as you hold on to the switch lever
of the light combination switch, the high
beam flashers will keep flashing and the
indicator light in the cluster will be illumi
-
nated.
Auto light (applicable to some
models)
-
Turn the ignition switch or start switch to
"ON" position.
-
Turning the light switch to Position AUTO
turns on the auto lighting function.
Hint
•
Enable AUTO LIGHT function. The
vehicle automatically turns on or
off the headlights based on ambient
light. When the ambient light out
-
side the vehicle dims, the position
lights are turned on, and then the
low beams. When the ambient light
outside the vehicle brightens, the
low beams go out, and then the po
-
sition lights. When entering a tunnel
or garage or other environment, the
position lights and low beams will
be automatically turned on at the
same time.
•
You can adjust auto light sensitiv
-
ity via the configuration menu of
multimedia display interface. The
higher the sensitivity, the brighter
the lights (refer to page 200).
A28
V5_2016-04-11.indd 81
2016/7/11 16:04:38
