G-U ELTRAL S 230, Installation, Operation And Maintenance Instructions

Page: 12 / 20

12
EN
Electric drive
Installation, operation and maintenance instructions
ELTRAL S 230
07.2019 | G36582 | Designed in Germany
3. Mounting
3.1 Mechanical
The assembly may only be carried out by trained professionals.
Remove the plastic covers on the front and rear of the drive by pulling them off in an upwards
direction.
Fasten the drive using the designated screw drill holes (4x) with an M5 or woodscrew up to d = 5 mm.
Fit the drive onto the window in such a way that it is accessible at any given time, and can be
exchanged if necessary.
For the transmission of force onto the window the rod is screwed into the spindle nut on the frontal
side (e.g. for fanlight openers). In order to do this, remove one of the frontal cover plugs.
For the assembly and installation of the drives, please bear the following in mind:
 
The required performance values (please see “Technical Data”) may be neither exceeded nor
undershot.
 
The values indicated on the dimension sheet are to be complied with during the installation of the
drive.
 
Be sure to verify whether your facility meets the necessary technical and electric requirements.
 
Always respect all country specific regulations for electric governance systems as well as all other
country specific regulations.
 
Always verify whether your facility meets the relevant requirements.
Pay special attention to the:
 
Cross-section of the window
 
Opening time/speed
 
Temperature resistance of the cables and drive
 
Cross-section of the cables in the governance system
The window and window frame must be constructed according to the strain caused by the
compressive and tractive force of the drive.
Danger during assembly
The warranty for the safe operation is dependent on the assemblers’ compliance with the safety
regulations. The handling and assembly of certain parts and components in an inappropriate manner
may lead to injuries under unfavourable circumstances.
Risk of injury through improper handling! Potential injury through crushing, shearing, cutting,
impact!
 
Follow the general construction and safety instructions for handling and assembly.
 
Use suitable assembly and transport facilities.
 
Prevent incarceration and crushing through suitable precautions.
 
Only use suitable tools.
 
Use lifting equipment and tools properly.
 
Use appropriate safety equipment (e.g. safety goggles, safety shoes) when necessary.
 
Do not stop beneath hanging loads.