G-Systems 16A, User Manual

Page: 14 / 15

or under cut of the set value you will receive an alarm message on the 9. Alarm LED on
the foil. Depending on the model you have there is a free contact in the inside of the
controller which is closed by alarm. You can read the alarm in the main screen part 3 and
confirm it with SAVE / EXIT button. Should the measured value still exceed the set alarm
value than the alarm get immediately activated again.
Go to the menu “Set alarm”. Choose the sensor and confirm with ENTER, choose now the
alarm value with UP / DOWN buttons. Push the ENTER button to change the value with
UP / DOWN buttons, save it with SAVE / EXIT button. Repeat this this procedure to
change all the other alarm values.
Recording of historical data (Only for model with USB recording):
Depending on the model you have, Recording of historical data is only for controllers with
USB connection.
Go to the menu “Set log file” under the sub menu “Rating” you can choose the Repetition
rate e.g: 5minutes. The controller will save all the data's every 5minutes to your USB
memory stick. Push ENTER button the value begins to blink, change the value with the UP
/ DOWN buttons, save it with SAVE / EXIT.
General limitations:
All firmware versions support BOMS devices formatted in FAT12, FAT16 or FAT32 file
systems only where the sector size is 512 bytes. No other file systems or sector sizes are
allowed.
Format only the USB memory stick on your computer (Windows 7, 8, 10) Plug the USB
memory stick into the USB socket on the controller. If you have set the memory frequency
to 5minutes so every 5minutes once will be written the current measurement data and
settings to the USB memory stick. Make sure when unplugging the USB memory stick
from the controller he is not saving the data's in this moment. Should this happens the file
can be damaged or even freeze the controller. A restart of the controller is required. Plug
the power cord for about 20 seconds from the mains.
Reset to factory settings:
Go to the sub menu "Res. factory set" change with UP / DOWN buttons from No? to Yes?
page 14 of 15
Max.temp. 32.3C°
Max.temp. 32.3C°
Min.temp.-12.6C°
Min.temp.-12.6C°
Sensor T1 temperature
Sensor T2 temperature
Max.humidity 60%
Min.humidity 10%
Sensor Rh humidity