GNW3324A GAS PRESSURE WASHER
29
10, STROAGE
10.1
FUEL STABILIZER
1)
Add fuel stabilizer to fuel tank to
minimize the formation of fuel gum
deposits during storage.
2)
Run engine at least 5 minutes after
adding stabilizer to allow it to enter the
fuel system.
NOTE:
If a fuel stabilizer is not used, all gasoline must be drained from
the tank and carburetor to prevent gum deposits from forming on these parts
and causing possible malfunction of the engine.
10.2
DRAINING FUEL
1)
Turn fuel valve to the “OFF” position,
remove drain hex screw from the
carburetor.
2)
Now turn fuel valve to the “ON” position
and drain the fuel from the tank, carburetor
and hose.
3)
Reposition the carburetor drain hex screw
once the fuel is completely drained.
10.3
DRAINING OIL
Refer to
→
PAGE 19 ENGINE MAINTAINENCE
.
10.4
RUST PROTECTION
1)
Pour approximately one teaspoon of
engine oil through the spark plug hole and
pull the recoil starter slowly until you feel
increased pressure which indicates the
piston is on its compression stroke and
leave it in this position. This closes both the
intake and exhaust valves to prevent the
inside of the cylinder from rusting.
FUEL STABILIZER
FUEL TANK
Engine
Oil
Spark
Plug
Draining
Bolt
