GNW3324A GAS PRESSURE WASHER
28
9.3
CLEANING CARBURETOR
1)
Screw down the bolt on the bottom of
carburetor with wrench.
2)
Push the float up four to five times, then
clean sediment cup with gas.
3)
Put the sediment cup back.
*** Be careful not to miss the O ring.
9.4
INSPECTING SPARK PLUG
The spark plug should be checked every 100 hours of operation or every
year.
9.5
REPLACING AND CLEANNING SPARK PLUG
1)
Dismantle the spark plug wire by pulling it off
the spark plug. Using the supplied spark plug
wrench, undo the spark plug by turning counter
clockwise.
2)
Check to see if there is carbon sediment build-
up, if so, remove it. If the carbon sediment is
excessive, replace the spark plug.
3)
Measure the electrodes clearance using a
feeler gauge. The spark plug electrode
clearance should be 0.7-0.8 mm. If the
clearance exceeds 0.8 mm, replace the spark plug.
4)
Reinstall spark plug in the reverse order.
