GNW2820A GAS PRESSURE WASHER
16
Spare O-rings
(two for high-pressure hose, one for quick-
connector)
Spray tip cleaner *1
Spray tip cleaner *1
Others:
Manual *1
；
Nozzle cleaner*1
；
Spark plug wrench *1.
WARNING! Before attempting to start pressure washer, ensure you complete the
following important steps.
1)
Fill gasoline tank with Unleaded Gasoline. This is a 4-cycle engine with separate
reservoirs for gas and oil.
DO NOT
use pre-mixed gas!
DO NOT
use old gas! Fuel must
be purchased separately.
2)
Fill oil tank with SAE 10W-30 oil. Running pressure washer without oil will severely
damage engine which is not covered by warranty! Oil must be purchased separately.
3)
Ensure both the pressure hose and garden hose have been correctly attached to the
pressure washer pump. Ensure the water tap is on and water is running through the
hose before attempting to start engine. Not doing this will damage the pump!
5, ASSEMBLY INSTRUCTIONS
5.1
Lift the frame with one hand and attach
one of the wheels by pressing the
wheel’s pin and inserting the wheel
shaft into the main frame. Align the pin
with the hole on the frame (A) until it
snaps in. Repeat for the opposite side.
5.2
Position handle assembly and main
frame and connect them with square
neck bolt, then fasten with the knob.
Repeat this procedure for the opposite
side. When storing the machine, you
can unscrew the knob and fold down
the frame.
