Plug your cabinet is plugged into a power source. An ON-OFF rocker
switch activates power to the heat module. Your Proofer/Heater is
equipped with two (2) heating elements and two (2) separate controls
which regulate these elements. The PROOF is an infinite control (1-7
or Low-Med-High settings) which regulates the amount of warmed
moisture in the cabinet. The HEAT control knob goes from 90°F to
190°F, and controls the amount of heat in the cabinet, when in use as
a holding unit only (if water is added to water pan during this mode,
some humidity will be added to the cabinet air to keep foods moist.
However, if dry heat is needed, it does not harm the cabinet to be used
without any water in the water pan). An operational range thermometer
shows the internal temperature of the cabinet.
5
CLEANING
FWE ETC CABINET WITH REMOVABLE PROOFER/HEATER
INSTALLATION AND CARE
Keep your cabinet clean by simply wiping the interior and
exterior, as needed, with a damp cloth or sponge and a mild
soapy solution.
!
CAUTION
NEVER USE ABRASIVES, ACIDS, OR STRONG
CLEANERS.
Do not flood or allow electrical parts to
become wet. The interior tray slide assemblies and
humidifier pans are removable for easy cleaning.
A stainless steel cleaner/polish is recommended for
the exterior to maintain a "like-new" appearance.
DO NOT USE WAX OR STRONG CLEANERS ON
DOOR GASKETS OR VINYL TRIM.
WARNING: BE SURE THE PROOFER / HEAT
MODULE IS UNPLUGGED OR REMOVED
BEFORE CLEANING CABINET.
THE WATER PAN
AND HEATING ELEMENT(S) ARE HOT WHEN IN
USE AND COULD CAUSE INJURY.
WARNING: DO NOT USE WET JET TO HOSE DOWN
HEAT MODULE. DO NOT RUN THROUGH DISH-
WASHER TO CLEAN REMOVABLE
PROOFER MODULE. DAMAGE TO ELECTRICAL
COMPONENTS WILL OCCUR.
PROOFER/HEATER CONTROLS
