FWE Removable Proofer/Heater Module or models operate on
120 volt, 60 Hz, 1 ph, A.C. (unless ordered otherwise), and are
equipped with a three prong grounding cord plug for your
protection against possible shock hazards. Be sure to plug only
into a properly grounded three prong wall receptacle. If you have
any questions with regard to adequate wiring or grounding in
your building, a qualified electrician should be contacted before
using your cabinet. The amperage of your heat module is
stamped on the name plate attached to the unit.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.
WARNING:
ONLY A QUALIFIED ELECTRICIAN SHOULD
ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.
BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.
FWE ETC CABINET WITH REMOVABLE PROOFER/HEATER
INSTALLATION AND CARE
ELECTRICAL REQUIREMENTS AND GROUNDING
SERIAL AND MODEL NUMBER
UNPACKING
These numbers are found on the nameplate (serial tag) affixed
to the lower back of the unit. Please record them in this booklet,
in the space provided. When ordering parts and/or service, you
will need to provide this information. The voltage and amperage
of the unit are also stamped on the serial tag.
After uncrating your cabinet and heating unit, remove all tape
and padding which held all doors, shelves, racks, cord, etc., in
place during shipment.
4
