FW Murphy Selectronic S1501 series, Installation And Operation Manual

Page: 26 / 34

Section 50 00-02-0271
2018-10-23 - 22 -
Sensor Set Up
The S1501 system allows you to edit the Shutdown Message, Class Type and Shutdown
Action (Shutdown Alarm or Alarm only) for each Sensor Input. Class Type are defined as
follows:
Class A, Shutdown
Class B1, Shutdown
Class B2, Shutdown
Class C, Shutdown
Class P, Shutdown
ESD Shutdown
Class A, Alarm
Class B1, Alarm
Class B2, Alarm
Class C, Alarm
Class P, Alarm
Ignore Point
Press
▲ UP/YES or ▼ DOWN/NO keys to select the input to modify. Select INPUT #0 to exit.
Press
■
■ ENTER once the desired input is chosen, and the corresponding shutdown message
will be displayed.
LOW OIL
PRESSURE
With the first character blinking you may change the character by pressing the
▲
▲ UP/YES or
▼ DOWN/NO keys to scroll through available characters. Press
■
■ MODE to move forward on
character, or
■
■ RESET to move backward. When the shutdown modification is completed,
press
■■
■ ENTER to save the new message. The Sensor Class Type and function will now be
displayed, for example:
SHUTDOWN TYPE
CLASS A SHUTDOWN
To change the Class Type and function, use the
▲
▲ UP/YES or ▼ DOWN/NO keys until the
desired combination of Class and Function is reached. Press the
■■
■ ENTER key to save and
return to the Setup screen. Repeat as above for all Sensors Inputs and Messages to be
edited.
Start/Stop Configuration
The S1501 system can be configured for Local and/or Remote Start-Stop. Start-Stop is
configured via terminal block inputs TB30 (local), TB31 (Remote).
Keypad Start
Jumper installed in TB30. A valid sequence occurs when the
■ START/STOP key is pressed.
Likewise, while running, a valid stop sequence occurs when the
■ START/STOP key is
pressed.