FUXTEC FX-AF1196, Manual

Page: 59 / 137

Original-Bedienungsanleitung FUXTEC FX-AF1196_de_en_fr_ita_rev02
59
7.6.3 Depth control lever
The milling depth is controlled by the height of the depth control lever. To
adjust the machining depth:
•
Loosen the depth regulator screw.
•
Adjust the depth control lever so that the chipping knives are at the
selected machining depth.
•
Tighten the screw of the depth regulator. Depth control lever
down = lower milling.
Insert the depth control lever screw into the depth control lever's upper
hole for the lowest machining depth.
Depth control lever up = deeper milling.
Insert the screw of the depth regulator into the lower hole of the depth
regulator lever for the most profound machining depth.
A Dowel pin C Depth
regulator
B Depth regulator bracket