Future EXPLORER MAGELLAN, User Manual

Page: 54 / 72

6 CHAIR ADJUSTMENTS
730 REV 09 DATE REV: 09/02/14 54 POWER CHAIR: EXPLORER MAGELLAN
(labeled A in Figure 14
) using a 3/16” Allen key or
bit. Once these four bolts are removed, the rear
support and seat are no longer anchored and will
tend to fall downwards. It can be useful to place
a piece of wood under the rear seat support arch
to it in place. Move the rear seat support until the
holes line up with the desired setting and reinstall
the 1/4-20 bolts and split washers, tightening to
150 in lbs of torque.
iii. Front seat support
To keep the same angle and just raise or lower
the seat height the same amount as the back,
loosen and remove the four bolts and split
washers near the top of the seat posts, labeled B
in Figure 13. Lift or lower the seat frame to the
desired height. Align the holes and reinsert the
bolts and split washers. This connection needs to
be tight. To change the seat angle, adjust the
location of the four bolts, flat washers and nuts at
the midway point of the front seat post. Each hole