30
Automatic Control
1. The Remote Switch Assembly is designed to mount to lever shafts from 3/8" to 1-1/8"
in diameter by using the different screws provided.
2. Determine Remote Switch mounting location for easy access during operation.
Cable should route downward from switch housing.
3. If mounted to a moving lever, ensure there is enough cable to permit full lever travel.
4. Remove any dirt or oils from the area where the switch will mount with isopropyl
alcohol or detergent cleaner.
5 Remove the adhesive liners on the double sticky tape and apply the switch.
5 Remove the adhesive liners on the double sticky tape and apply the switch.
6 Select the correct length of screw for the shaft diameter and tighten clamping
6 Select the correct length of screw for the shaft diameter and tighten clamping
screws. Do not overtighten as this can distort housing and clamp.
screws. Do not overtighten as this can distort housing and clamp.
7 Strain relief the cable by tie wrapping it to the lever as shown.
7 Strain relief the cable by tie wrapping it to the lever as shown.
8. Check the function with the control box.
5 Remove the adhesive liners on the double sticky tape and apply the switch.
6 Select the correct length of screw for the shaft diameter and tighten clamping
7 Strain relief the cable by tie wrapping it to the lever as shown.
APPENDIX K
Miscellaneous Installation Information
Remote Switch Installation Notes:
Receiver Cable with Mounting Block Installation Notes:
Switch Orientation View
Mounting Options For ATI-024019-XX
Grill Mounting
Grill Mounting
JD 450-650H Dozers
1 Notch top fi n for strain relief
clearance & mount to grill.
2. Leave service loop for
opening grill.
1 Notch top fi n for strain relief
Grill Mounting
Grill Mounting
CAT D3-D5G Dozers
- Loosen top radiator mounts
to provide clearance for cable
connector routing past radiator.
Hood Mounting
Mounting
- If no access for cable around
radiator, lay block on its side &
mount to top of hood.
