35
Servo reversing
(
REVERSE
): changes the direction an individual servo responds to a
CONTROL STICK
motion.
)RU&&30KHOLFRSWHUVEHVXUHWRUHDGWKHVHFWLRQRQ
SWASH AFR
(p. 75) before reversing any servos.
With the exception of CCPM helicopters, always complete your servo reversing prior to any other programming.
When using
ACRO
functions that control multiple servos, such as
FLAPERON
or
V-TAIL
, it may be confusing to determine
whether the servo needs to be reversed or a setting in the function needs to
be reversed. Refer to the instructions for each specialized function for further
details.
Always check servo direction prior to every flight as an additional
SUHFDXWLRQWRFRQ¿UPSURSHUPRGHOPHPRU\KRRNXSVDQGUDGLRIXQFWLRQ
NOTE:
THR-REV
is a special function that reverses the entire throttle control, including moving the trim functionality to
WKH6WLFN¶VXSSHUKDOI7RXVH
THR-REV
: see p.92. This change affects all models in the radio.
GOAL of EXAMPLE:
STEPS:
INPUTS:
Reverse the direction of the elevator
servo.
Open
REVERSE
function.
for 1 second.
to
REVERSE
.
C h o o s e p r o p e r c h a n n e l a n d s e t
direction. (Ex:
ELE REV
)
to
ELE
.
for 1 second.
&RQ¿UP\RXUFKDQJH
Sure?
displays.
Close.
Where next?
Adjust servo travel with
END POINT
: see p. 36.
Set up dual/triple rates and exponential(
D/R
,
EXP
): see p. 39.
6HWXSÀLJKWWLPHUVVHHS
Set up trainer functions: see p. 44.
[ T8J of the transmits side ]
1. The data of a model to send is called by MDL-SEL.
2. MODE of MDL-TRANS is set to “TRANSFER” .
3. “Execute” .
[ T8J of the receives side ]
*It receives for 10 seconds.
1. The clear model is called by MDL-SEL.
2. MODE of MDL-TRANS is set to “RECEIVE” .
3. “Execute” .
MDL-TRANS
Summary of Contents for T8J-2.4G
Page 93: ...93...
