FUTABA T4PM, Instruction Manual

Page: 34 / 136

The servo operation confi rmation message is dis-
played. With this screen displayed, turn the power
of the receiver off and on again and check the op-
eration of the servo by actually operating it. If the
servo does not operate properly, check the SR
mode setting of the servo. Press the [END] button
to close the screen.
To c h a n g e S R m o d e
setting, press the (JOG)
button, and to cancel,
press the [END] button.
(JOG) button to select the
SBU servo and then press this
button to display the S.BUS
servo screen.
(JOG) button to
select a channel
Use the (+) and
(-) buttons to se-
lect ON / OFF of
SR mode.
Caution
Be sure to use the T4PM receiver setting and the servo to be used under predetermined conditions.
Under other conditions, the set will not operate, or the specifi ed performance will not be displayed even if it operates. In addition, it
may cause servo trouble. Futaba will not be responsible for problems caused by the use of other than Futaba genuine parts. Use the
parts specifi ed in the instruction manual and catalog.
System
Response / SR node Usable servos
T-FHSS SR
SR mode channel: ON
-SR mode of Futaba SR compatible servo.
6HHSDJHIRUFXUUHQWOLVWLQJV
SR mode channel: OFF
- Normal mode of Futaba SR compatible servo.
- Futaba digital servo.
T-FHSS
HI-SPEED mode
- Normal mode of Futaba SR compatible servo.
- Futaba digital servo.
NORMAL mode
- Futaba all servo.
1RUPDOPRGHRI)XWDED65FRPSDWLEOHVHUYR
S-FHSS
HI-SPEED mode
- Normal mode of Futaba SR compatible servo.
- Futaba digital servo.
NORMAL mode
- Futaba all servo.
1RUPDOPRGHRI)XWDED65FRPSDWLEOHVHUYR
Servo mode setting and corresponding servo of each system
34
In
itial S
e
t-
Up
How to set the SR mode Channel
,QWKHF6665
"
SR mode
"
ZKLFKKDVJUHDWO\LPSURYHGUHVSRQVHFRPSDUHG
WRWKHFRQYHQW66FDQEHXVHG7KHGLVSOD\FKDQJHVZKHQ\RXFKDQJHLW%H
VXUHWRWXUQRIIWKHSRZHURIWKHUHFHLYHUEHIRUHRSHUDWLRQFKHFN
,Q65PRGH212))FDQEHVHWIRUHDFKFKDQQHO:KHQXVLQJQRUPDOVHUYRRU(6&
VHWWKH65PRGHRIWKHFRQQHFWHGFKDQQHOWR2))
Note:
In SR mode ON, normal servo, ESC and gyro will not operate. Please set our S.BUS servo corre-
sponding to SR mode to SR mode on S.BUS servo menu and use it. Also, in case of SR mode OFF, the servo
set to SR mode cannot be used, so set the servo to normal mode by S. BUS servo menu. If using wrong com-
bination, servo and other equipment will fail, so please be careful.
*Refer to country distributor WEB for detailed the "S. BUS servo menu" and the "SR mode setting" explana-
tion.