FUTABA T4PM, Instruction Manual

Page: 103 / 136

103
Fu
n
c
ti
o
n
Dual ESC Mixing "DUAL ESC"
The programmed DT button is used to select the drive type as
shown in the fi gure below.
7KHIXQFWLRQVHOHFWGLDOIXQFWLRQFDQFRQWUROWKHWKFKDQQHO¶V(6&5HDUVLGHUDWH
5$7(ZLWKGLJLWDOGLDORUGLJLWDOWULPXVLQJWKHIXQFWLRQVHOHFWWULPGLDOIXQFWLRQ
6HHSDJH
Dial / Trim Setting
$VWKLVIXQFWLRQGULYHVVHSDUDWHPRWRUFRQWUROOHUVVLPXOWDQHRXVO\DPXWXDOORDG
LVDSSOLHG8VHWKLVIXQFWLRQFDUHIXOO\VRWKDWWKHPRWRUFRQWUROOHUVDUHQRWGDPDJHG
)XWDEDZLOOQRWEHUHVSRQVLEOHIRUPRWRUFRQWUROOHUPRWRUDQGRWKHUYHKLFOHWURXEOH
due to use of this function.
Note:
Rear rate (RATE)
0 ~ 120
Initial value:100
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Mixing mode (MXMD)
OFF, ON
Initial value: OFF
Trim mode (TRIM)
OFF, ON
Initial value: OFF
2
(Rear side travel adjustment)
Select the setting item "RATE" by moving the (JOG) button up
or down. Use when applying a rotation difference to the front
and rear wheels by adjusting the rear (CH4) motor controller
travel with the (+) or (-) button.
3
(Mix mode setting)
Select the setting item "MXMD" by moving the (JOG) button up
or down. Set the mix mode with the (+) or (-) button.
"
2))
"
&+(;3IXQFWLRQDQGRWKHUVHWWLQJVDUHQRWPL[HG
"
21
"
&+(;3IXQFWLRQDQGRWKHUVHWWLQJVDUHPL[HG
4
(Trim mode setting)
Select the setting item "TRIM" by moving the (JOG) button up
or down. Set the trim mode with the (+) or (-) button.
"
2))
"
)URQWVLGH&+WULPGDWDLVQRWLQFOXGHG
"
21
"
)URQWVLGH&+WULPGDWDLVLQFOXGHG
5
When finished with the setting, return to the MENU screen by
pressing the (END) button.
Select button
- Select with the (+) or (-) but-
tons.
Select button
- Select with the (+) or (-) but-
tons.