66
<Functions of System Menu>
%RRVW212))
OFF : It is the boost ON at the time of low-speed operation.(In the case of usual)
ON : It is always the boost ON.(When quick operation is hope)
'DPSHU
The characteristic when the servo is stopped can be set.
When smaller than the standard value, the characteristic becomes an overshoot characteristic. If the value is
larger than the standard value, the brake is applied before the stop position.
Especially, when a large load is applied, overshoot, etc. are suppressed by inertia and hunting may occur,
depending on the conditions. If hunting (phenomena which cause the servo to oscillate) occurs even though the
Dead Band, Stretcher, Boost and other parameters are suitable, adjust this parameter to a value larger than the
initial value.
[Relationship between damper set value and servo operation]
Small
ĺ
When you want to overshoot. Set so that hunting does not occur.
Large
ĺ
When you want to operate so that braking is not applied. However, it will feel like the servo response has
worsened.
(Note)
If used in the hunting state, not only will the current consumption increase, but the life of the servo will also
be shortened.
6WUHWFKHU
The servo hold characteristic can be set. The torque which attempts to return the servo to the target position
when the current servo position has deviated from the target position can be adjusted.
This is used when stopping hunting, etc., but the holding characteristic changes as shown below.
[Relationship between stretcher and servo operation]
Small
ĺ
Servo holding force becomes weaker.
Large
ĺ
Servo holding force becomes stronger.
(Note)
When this parameter is large, the current consumption increases.
%X]]HU
When the power supply of a servo is previously turned on at the time of a power supply injection without taking
transmit of a transmitter, the buzzer sound of about 2.5 Hz continues sounding from a servo.
(Even when the transmit of a transmitter is taken out previously, a buzzer becomes until the signal of a servo is
outputted normally, but it is not unusual.)
The transmitter has been turned OFF ahead of a servo power supply
→
The buzzer sound of about 1.25 Hz
continues sounding as servo power supply end failure alarm.
(
Do not insert or remove the servo connector while the receiver power is ON.
A buzzer may sound
by incorrect recognition.
)
＊
Buzzer sound is generated by vibrating the motor of a servo.
Since current is consumed and a servo generates heat, please do not operate the number more than needed or
do not continue sounding a buzzer for a long time.
