Warning!
The appliance must not be
installed behind the lockable door, a
sliding door or a door with a hinge on the
opposite side to that of the appliance.
Removing transport safety packaging
Caution!
Before use all parts of the
transport packaging must be removed.
1. Open loading door.
2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene padding
from the machine.
Fitting the vent hose
To simplify the installation, there is a choice
of vent outlets: one at the back, the others in
the left and right-hand side. Connect the
hose to whichever is the more convenient by
pulling the ring nut (A) from the vent outlet at
the back, screwing it on to the hose and
pushing it firmly back into place. The unused
vents should now be sealed with the special
snap covers provided.
If the hose is long and the room temperature
low, the moisture might condense to water
inside the hose. This is an unavoidable nat-
ural phenomenon. To prevent this water from
Iying in the hose or flowing back into the tum-
ble dryer, it is advisable to drill a small hole
(via. 3 mm) in the lowest point of the hose and
to place a small container below it. (See pic-
ture, point B).
A
A
12
