Electrical connection
Details on mains voltage, type of current and
the fuses required should be taken from the
type plate. The type plate is fitted near the
loading aperture (see “Product description”
chapter).
Warning!
The manufacturer declines
any responsibility for damage or injury
through failure to comply with the above
safety precautions.
Should the appliance power supply ca-
ble need to be replaced, this must be
carried out by our Service Center.
Warning!
The power supply cable must
be accessible after installing the
machine.
Door reversal
Warning!
Before changing the door
stop, disconnect the mains plug.
1.
A
C
A
B
B
Open loading door.
2. Unscrew hinge
A
from the front of the
machine and take off the loading door.
3. Remove cover plates
B
. To do this, in-
sert a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
4. Use an appropriate tool and exert pres-
sure to unfasten locking block
C
from the
snap-on fixture, take out and re-insert on
the other side having rotated the block
through 180°.
5. Unscrew hinge
A
from the loading door,
rotate through 180°, re-insert on the op-
posite side and screw down.
6. Re-insert cover plates
B
on the opposite
site having first rotated them through
180°.
19
Summary of Contents for Novamatic TW 7757
