To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid
dispenser.
3. Adjust the water hardness setting
to the highest level.
4. Do a washing programme without
dishes.
5. Adjust the water softener to the
water hardness in your area.
6. Adjust the rinse aid dosage.
SETTING AND STARTING A WASHING PROGRAMME
Set the washing programme with the
door ajar. The washing programme on-
ly starts after you close the door. Until
then it is possible to modify the set-
tings.
Do these steps to set and start a washing
programme:
1. Switch on the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press the programme button and se-
lect a washing programme. The digital
display shows the programme number.
Refer to the chapter 'Washing pro-
grammes'.
– The programme button indicator light
flashes.
– The phase indicator lights for the
washing programme flash.
4. If necessary, set one or more options.
Refer to the chapter 'Washing pro-
grammes' and make sure that the op-
tion is available with the set pro-
gramme.
5. Close the door.
– The washing programme starts auto-
matically.
– The phase indicator lights go off but
not the indicator light of the phase in
operation.
– The programme button indicator light
is on with a static light.
– The digital display shows the dura-
tion time of the washing programme.
When the washing programme oper-
ates, you cannot change the pro-
gramme. Cancel the washing pro-
gramme.
Warning!
Only interrupt or cancel a
washing programme if necessary.
Caution!
Open the door carefully. Hot
steam can come free.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point
of interruption.
Cancelling a washing programme
1. Press and hold function buttons B and
C until 2 horizontal bars show in the
digital display.
2. Release function buttons B and C to
cancel the washing programme.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme .
Fill the detergent dispenser with detergent
before you set a new washing programme.
Setting and starting a washing
programme with delay start
1. Press the on/off button.
2. Set a washing programme.
3. Press the delay start button until the
display shows on flashing the necessa-
ry delay start of the washing pro-
gramme.
4. Close the door.
– The number on the display comes on
with fixed light.
– The countdown of the delay start
starts.
– The countdown of the delay start de-
creases with steps of 1 hour.
– When the countdown is completed,
the washing programme starts auto-
matically.
Do not open the door during the count-
down to prevent interruption of the
countdown. When you close the door
again, the countdown continues from
the point of interruption.
38
