10
Figure 11: Control Panel
1.
Print head current temperature
2.
Print head set point (0 means the heater is off)
3.
Heat bed current temperature and set point
4.
Print head position in XYZ space
5.
Feed rate (turning this knob will increase or decrease the print speed in real time
6.
Indicates % complete while a print is running
7.
Print elapsed time
8.
Message row
4.2.
Precautions
Moving Components By Hand
If you need to move the print head, X crossbar, or Z axis by hand, you should
do this with your F306 powered ON
,
but the stepper motors disabled (Prepare -> Disable Motors). Move components gently and do not move them
too quickly.
Particularly on the print head, do not use the cooling fan as a grab point. The proper method is to grasp the sides
of the carriage with your fingers as shown.
Summary of Contents for F306 Generation I
