Furuno TZT19F, Installation Manual

Page: 50 / 58

3. HOW TO SET UP THE EQUIPMENT
3-18
3.6 Wireless LAN Setting
3.6.1 How to join an existing wireless network
By connecting to an existing network, you may download software updates and
weather information from the internet.
1. Tap the Home icon to show the home screen and display mode settings.
2. Tap [Settings], then [General].
3. Tap [Wireless LAN Settings].
4. Tap [Wireless Mode].
5. Tap [Connect to existing LAN], then tap the [<] icon at the top left of the
display.
6. Tap [Wireless] in the [ENABLE WIRELESS] menu.
7. Tap [Scan] to scan the vicinity for accessible WLAN networks. Available networks
are listed. To delete all WLAN networks, select [Forget All Available Networks].
8. Tap the appropriate WLAN network to show the following display.
Menu item Description
Options
(setting range)
[Motion Sensor
Type] Select the sensor connected to your TZT19F unit. For all
sensors other than SC-50 and SC-110, select [SC-30].
Note: This menu item is not available when [Fish Finder
Source] is set to [TZT19F].
[SC30],
[SC50_SC110]
[Antenna Posi-
tion Bow/Stern
HF (LF)] Set the distance from the antenna unit to the transducer in
the bow-stern direction. If the transducer is located on the
fore side, set a positive value. [-99.9] to [+99.9]
[Antenna Posi-
tion Up/Down HF
(LF)] Set the distance from the transducer to the antenna unit in
the vertical direction.If the transducer is located on the bow
side, set a positive value. [-0.00] to [+99.9]
[Antenna Port/
Starboard HF
(LF)] Set the distance from the antenna unit to the transducer in
the port-starboard direction. If the transducer is located on
the starboard side, set a positive value. [-99.9] to [+99.9]
Up/Down Up/Down
Bow/Stern for HF Bow/Stern for HF
Bow/Stern for LF Bow/Stern for LF
Port/Starboard for HF Port/Starboard for HF
Port/Starboard for LF Port/Starboard for LF
HF Transducer HF Transducer
LF Transducer LF Transducer
SC-30/33/50/70/110/130
CANCEL
FORGET
CONNECT