Furuno TZT19F, Installation Manual

Page: 16 / 58

1. MOUNTING
1-8
14. Tap the [<] icon twice to return to the [Fish Finder] menu, then scroll the [Fish Find-
er] to show the [FISH FINDER INITIAL SETUP] menu.
15. At the [Transmission Power] menu item, set the transmission power to a level of
[Max].
16. Scroll the menu to show [Fish Finder Transmit], then tap [Fish Finder Transmit].
Check if the bottom echo appears on the right side of the screen, in the display
area.
If no bottom echo appears, repeat the procedure until a suitable location is found.
17. Turn off the power of control unit and remove the transducer from the plastic bag
and wipe the face of transducer with a cloth to remove water and any foreign ma-
terial.
Installation procedure
1. Lightly roughen the transducer face with #100 sandpaper. Also, use the sandpa-
per to roughen the inside of the hull where the transducer is to be mounted. Wipe
off any sandpaper dust from the face of the transducer.
2. Dry the face of the transducer and the hull. Coat the transducer face and mounting
location with marine sealant. Hardening begins in approx. 15 to 20 minutes so do
this step without delay.
3. Attach the transducer to the hull. Press the transducer firmly down on the hull and
gently twist it back and forth to remove any air which may be trapped in the marine
sealant.
4. Support the transducer with a piece of wood to keep it in place while the sealant
is drying. It takes 24 to 72 hours to harden completely.
5. Turn the power on and change the menu setting as shown below. See section 3.3
for how to use the menu.
1) Tap the [Home] icon to show the home screen and display mode settings.
2) Scroll the menu to show [Fish Finder] in the menu, then tap [FISH FINDER
INITIAL SETUP] menu.
3) At the [Transmission Power Mode] menu item, set the transmission power to
a level of [Max].
Transducer
Marine sealant
Hull
Marine sealant