![Furuno TZT19F Installation Manual Download Page 15](http://html1.mh-extra.com/html/furuno/tzt19f/tzt19f_installation-manual_2350510015.webp)
1. MOUNTING
1-7
Selecting a location to install the transducer
Install the transducer on the hull plate inside of the engine room. The attenuation of
the ultrasound pulse varies with the thickness of the hull. Select a location where at-
tenuation is the lowest.
Select 2-3 locations considering the four points mentioned below.
Decide the most suitable site from the locations selected with the following proce-
dures.
1. Connect the power cable and transducer cable to the display unit.
2. Put the transducer into a water-filled plastic bag.
Press the transducer against the chosen site.
3. Tap
(power switch) to turn the power on.
4. After the startup procedure completes (approx. 90
seconds), the last used display appears. Tap the
[Home] icon (
) to show the home
screen and display mode settings. See section 3.3
for how to use the menu.
5. Scroll the menu to show [Fish Finder] in the menu, then tap [Fish Finder].
6. Scroll the [Fish Finder] menu to show the [FISH FINDER INITIAL SETUP] menu,
then tap [Fish Finder Source].
7. Confirm the available fish finder from the list of available sounders, then tap the
appropriate fish finder. For the purpose of this example, the default setting
[TZT19F] (internal sounder) is selected as the source.
8. Tap the [<] icon to return to the [Fish Finder] menu.
9. Scroll the [Fish Finder] menu to show the [FISH FINDER INITIAL SETUP] menu,
then tap [Transducer Setup].
10. Tap [Transducer Setup Type].
11. Tap [Model].
12. Tap the [<] icon to return to [Transducer Setup] menu.
13. Tap [Model Number], scroll the menu to show your transducer model, then tap the
transducer model number.
• Mount the transducer at a location 1/2 to 1/3 of the length of your boat from the
stern.
• The mounting location is between 15 to 50 cm from the centerline of the hull.
• Do not place the transducer over hull struts or ribs which run under the hull.
• Avoid a location where the rising angle of the hull exceeds 15°, to minimize the
effect of the boat's rolling.
1/3
1/2
Centerline
Transducer mounting location
50 cm
50 cm
15 cm
15 cm
Plastic bag
Water
Hull plate
Home
Summary of Contents for TZT19F
Page 55: ...18 Dec 2019 H MAKI D 1...
Page 56: ...11 Nov 2019 H MAKI D 2...