Furuno NAVpilot 711C, Operator'S Manual

Page: 16 / 176

1. OPERATIONAL OVERVIEW
1-2
1.2 How to Turn the Power On/Off
Note: When the heading sensor PG-500/PG-700 is connected, turn on the NAVpilot
and wait four minutes before you leave port. This allows time for the PG-500/PG-700
heading data to stabilize.
1.2.1 How to power the system
Press the key to power the system. A beep sounds and the result of the start up
test appears followed by the start screen. The startup test checks the ROM, RAM and
backup of the processor unit and control unit. The test also checks for the presence of
heading from the heading sensor and rudder angle information from the rudder refer-
ence unit.
Note: The content of the startup test changes according to your system configuration.
If “NG” appears for any item, an error message, shown in the table below, appears.
Follow the information provided in the message to restore normal operation. If you
cannot restore normal operation, contact your dealer.
1.2.2 How to power off the system
Long press the key to power off the system. While pressing the key, the display
shows the number of seconds remaining until the power is turned off.
Error message Meaning
System has failed startup test. Please contact a lo-
cal FURUNO representative for repair if problem
re-occurs. The system has failed the start up
test.
Back-up data is corrupt factory defaults will be re-
stored (processor). Push any key to continue. Backup data of the processor unit
is corrupted.
Back-up data is corrupt factory defaults will be re-
stored (controller). Push any key to continue. Backup data of the control unit is
corrupted.
Cannot receive heading data. Please check the
heading sensor. Problem with heading sensor.
EVC Interface has failed startup test. Please con-
tact a local FURUNO representative for repair.
Push any key to continue. System error of the IPS interface
unit or NMEA data converter. Turn
off the autopilot, contact your deal-
er.
No connect EVC Interface. Please check the EVC
Interface. Push check the heading sensor. The IPS interface unit or NMEA
data converter is not connected.
Check the connection with IPS in-
terface unit or NMEA data convert-
er.
NAVpilot-711C Startup Test
Processor 6454007-**.**
Controller 6454011-**.**
ROM RAM Backup
Processor OK OK OK
Controller OK OK OK
Heading Sensor OK xx.x
°
RRU OK P12.3
°
Controller ID: 1
**.** : Program version no.