Furuno NAVpilot 711C, Operator'S Manual

Page: 157 / 176

7. INITIAL SETTINGS
7-45
7.17 RC (Remote Controller) Setup Menu
The [RC Setup] menu sets the type of remote controller connected to the NAVpilot. To
open the [RC Setup] menu, select [RC Setup] from the [Installation Menu] window.
Note: The [RC Setup] menu is not shown in case of Fantum Feedback
™
.
1. The cursor is selecting the current setting for [Remote Controller1]; push the
Course control knob.
2. Rotate the Course control knob to select the type of remote controller connected
then push the knob.
[NFU]: Select for lever-type remote controller.
[FU]: Select for dial-type remote controller
[Dodge]: Select for dodge-type remote controller.
[Disable]: Disable remote controller operation.
3. Set the type for [Remote Controller2], if connected.
7.18 All Clear (Default Setting)
The all clear feature restores all default settings.
1. In the STBY mode, push the Course control knob three times while pressing the
key.
The [Installation Menu] window appears.
2. Rotate the Course control knob to select [System Setup] then push the knob.
3. Rotate the Course control knob to select the option for [Restore Factory Setting]
then push the knob.
4. Rotate the Course control knob to select [Yes] then push the knob.
RC Setup
Remote Conroller1: Disable
Remote Conroller2: Disable