Furuno GP-1850WDF, Installation Manual

Page: 51 / 74

4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1850WF)
4-5
5. Close the cover of GR-7000A passing the two cables out through respective notches in
the cover.
6. Plug PH6P-W-L240 connector to J2 on the GR-7000A through the cover.
7. Wire cable assembly as shown in the figure below.
Reattach this tape as
shown right after the
DGPS connection.
To J8 of
ANLG Board
GN-8901
J1
GR-7000A
J2
J3
Connector
PH6P-W-L240
J2
Wiring the Cable assembly
8. Mount the ANLG board on the heat sink referring to step 2. Fasten cable assy.
S.FL2-2LP0.7-D-WHT (250), 8P connector cable and 6P connector cable by cable tie
(CV-100, supplied) as shown in the figure below. Fix cable assy. S.FL2-2LP0.7-D-WHT
(250) with vinyl tape.
J8
ANLG Board
6P connector
GN-8091
Cable
tie
8P connector
40 to 45 mm
10 mm
10 mm
MAIN Board
40 to 45 mm
Vinyl tape
Attaching cable tie
www.reelschematic.com
www.reelschematic.com