Furuno GP-1850WDF, Installation Manual

Page: 12 / 74

1. INSTALLATION
1-4
1.3 Installation of Transducers
Installing the inside-hull mount transducer
Necessary tools
You will need the following tools:
•
Sandpaper (#100)
•
Silicone sealant
Remarks on installation
•
Do the installation with the boat hauled out of the water.
•
Turn off the engine while installing the equipment.
•
Install the transducer in the engine room.
Selecting the mounting location
Keep the following points in mind when selecting a mounting location:
•
The mounting location should be where the hull is of single-hull thickness and is void of air
or flotation materials other than solid fiberglass between the transducer face and the water.
•
Do not place the transducer over hull struts or ribs which run under the hull.
•
Avoid a location where the rising angle of the hull exceeds 15°, to minimize the effect of the
boat’s rolling.
•
You will finalize the mounting location through some trial and error. The procedure for this is
shown later.
50 cm
50 cm
15 cm
15 cm
1/3
1/2
Mounting location
for transducer
Centerline
Inside-hull transducer mounting location
www.reelschematic.com
www.reelschematic.com