Furuno FELCOM19 Inmarsat Mini-C MES, Installation Manual

Page: 16 / 51

2. WIRING
2-6
2.1.3 12D-SFA-LITE-CV (100 m)
15
10
2
5
30
95
Outer sheath
Clamp nut
Gasket
Clamp
Washer
Clamp nut
Shell
Pin
Solder through
the hole.
Trim shield here.
Expose the insulator by 2 mm
Expose the conductor (core) by 5 mm.
Trim aluminum
tape here.
Dimensions in millimeters
Heat shrinkable tube or vinyl tape
Inner sheath
Armor Shield
Remove outer sheath and armor by the
dimensions shown left.
Remove inner sheath and expose shield
by the dimensions shown left.
Remove the insulator beneath shield by
10 mm and expose the core.
Slip on clamp nut, washer, gasket and
clamp as shown left.
Fold back shield over clamp and trim.
Cut aluminum tape at four places, 90°
from one another.
Fold back aluminum tape over clamp and
trim.
Slip the pin onto the conductor. Solder
them together through the hole on the pin.
Insert the pin into the shell. Screw the
clamp nut into the shell.
Tighten them by turning the clamp nut.
(Do not tighten by turning the shell.)
Twist shield end.