Furuno FELCOM19 Inmarsat Mini-C MES, Installation Manual, Page: 14 / 51

2. WIRING
2-4
Connector type N-P-8D-FB
50 30
30
10
5
Remove outer sheath and armor by the
dimensions shown left.
Expose inner sheath and shield by the dimen-
sions shown left.
Remove insulator and core by 10 mm.
Slip on clamp nut, gasket and clamp as shown
left.
Fold back shield over clamp and trim.
Fold back alminum tape foil onto shield and
trim.
Slip the pin onto the conductor. Solder them
together through the hole on the pin.
Expose the insulator by 1 mm.
Expose the core by 1 mm.
Insert the pin into the shell. Screw the clamp
nut into the shell.
(Tighten by turning the clamp nut. Do not
tighten by turning the shell.)
Cut alminum foil at four places, 90° from one
another.
Twist shield end.
Outer Sheath
Inner Sheath Shield
Dimensions in millimeters.
Cover with heat-shrink tubing and heat.
Armor
Clamp Nut
Clamp Nut
Pin
Aluminum Foil
Insulator
Shell
Trim shield here.
Trim alminum tape foil here.
Solder through the hole.
U-shaped groove
Clamp
Gasket (reddish brown)