Furuno FELCOM 70, Operator'S Manual

Page: 15 / 216

2. OPERATION FROM HANDSET
2-3
OK
> Active MSN
Kayclick
Ringer
Answer beep
Backlight
Language
MSN
Protocol
Set to Fleet
MENU
2.3 SIM card
The SIM card carries subscription information from your Net service provider on
an integrated circuit. The FELCOM 70 used with the SIM card assumes the
identity of the SIM card.
The SIM card has its own set of Inmarsat Mobile Numbers (IMN) on which the
user can be contacted irrespective of the FELCOM 70 used. All outgoing calls
will be billed to the owner of the SIM card.
The SIM card is protected by a SIM PIN (Personal Identification Number).
Contact your Net service provider if you do not have the PIN code.
If the PIN code entered does not match the PIN code on the SIM card, operation
with that particular SIM card will lock-up after three failed attempts. You must
then use the SIM un-block code (PUK code) provided by your Net service
provider to un-lock the card. Contact your Net service provider if you do not
have the PUK code.
Note:
When the PUK is used, the SIM PIN is set to 1 2 3 4.
To change or disable the PIN code,
see " 5.3 Access level " later in this manual.
The SIM card can store various information, e.g.:
•
PIN code (Personal Identification Number)
• Phone book
•
Allowed and preferred Net service providers
Note:
FELCOM 70 can be used with or without SIM card. The Net service
provider, however, sometimes requires the use of SIM card.
The SIM card driver is located on the upper end of the Communication Unit,
see
page 2-3
. The cover must be removed to access the card slot. The cover is
attached by two serrated screws. No tools are required to loosen the screws.
Note:
Turn on the power, wait for the indication “Ready for call”, and then insert
the SIM card. If the ship’s mains is turned off instantaneously, eject the
SIM card and turn the power off and on again.
2.4 ISDN Handset
When connected, the handset is automatically set to Fleet mode, providing an
idle display as shown on next page.
To switch back to ISDN Handset mode, press and hold down
DEL
when turning
ON power.
Switching back to Fleet mode is then achieved as follows:
1. Open the
MENU
and scroll down
to
Set to Fleet
2. Press
OK
.
The handset will now
stay in Fleet mode.