Furuno CH-500, Installation Manual

Page: 65 / 129

3. CHECKING AND INITIAL SETTINGS
3-7
1. Measure the roll and pitch angles of the two locations shown in the following fig-
ure, using a angle meter. When the raise/lower control unit is not separated from
the hull unit, go to next step.
2. Press the MENU key to open the menu.
3. Press
X
on the cursorpad to select [COM2] on the menu bar.
4. Press
T
to move the cursor inside the menu.
5. Press T several times to select [Roll Offset]. When the raise/lower control unit is
not separated from the hull unit, go to step 11
6. Press X to open the setting window.
7. Press W or X to adjust the offset value.
Calculate the offset value for [Roll Offset], using the values measured at step 1.
• [Roll Offset] = "Hull unit’s roll angle" minus "Raise/Lower control unit’s roll an-
gle"
8. Press T to select [Pitch Offset].
Roll Offset
Pitch Offset
Sensor Correct
Bow
Measure the roll and pitch
angles of these locations.
+
- +
-
+ -
Disab
le t
ran
sdu
ce r
ୖୗ
ື
೵Ṇ
ON
OFF
PO
WE
R
Refe
ren
ce
dire
ctio
n
ᇶ
ࠉ
‽ࠉ
᪉
ࠉྥ
rai
se/lowe
r func
tion
Disable transducer
ୖୗື೵Ṇ
ON
OFF
POWER
Reference direction
ᇶࠉ‽ࠉ᪉ࠉྥ
raise/lower function
Hull unit Raise/lower control unit
Menu
: Select : Change Menu: Apply
COM1 COM2 HOR. VERT ES FUNC Key System
No
Off
Off
32
3
Relative
+0
+0.0
+0.0
+0 Delete Track
White Marker
Erase Color
Echo Colors
BKGD. Colors
Bearing
Heading
Roll Offset
Pitch Offset
Sensor Correct
Delete sonar track.
Menu
: Select : Change Menu: Apply
COM1 COM2 HOR. VERT ES FUNC Key System
No
Compress
Off
Off
32
3
Relative
+0
+0.0
+0.0
+0 Delete Track
Mix Mode
White Marker
Erase Color
Echo Colors
BKGD. Colors
Bearing
Heading
Roll Offset
Pitch Offset
Sensor Correct
Delete sonar track.
For CH-600 For CH-500
Roll Offset
+0.0°
(-10.0~+10.0
°)
Detect Val : - - Compensated value
appears here.