Furuno CH-500, Installation Manual

Page: 66 / 129

3. CHECKING AND INITIAL SETTINGS
3-8
9. Press X to open the setting window.
10. Press W or X to adjust the offset value.
Calculate the offset value for [Pitch Angle], using the values measured at step 1.
• [Pitch Offset] = "Hull unit’s pitch angle" minus "Raise/Lower control unit’s pitch
angle"
11. Press T to select [Sensor Correct].
12. Press X to open the setting window.
13. Press W or X to adjust the offset value.
The [Reference direction] mark on the raise/lower
control unit should face the ship’s bow. When the
mark is skewed 2° in the starboard direction, enter
“+2°” to [Sensor Correct].
Note: When the raise/lower control unit is not separated from the hull unit, enter
the same value as the heading alignment value (see section 3.3).
14. Press the MENU key to apply the settings.
15. Press the MENU key to close [System Menu].
3.7 Navigation Equipment Setup
Do the following settings depending on the external equipment connected.
1. Press the MENU key to open the menu.
2. Press X to select [System] on the menu bar.
3. Press T to move the cursor inside the menu.
4. Press W to select [Yes] to open [System Menu].
5. [System Settings] is selected with the cursor; press X .
Pitch Offset
+0.0°
(-10.0~+10.0 °)
Detect Val : - - Compensated value
appears here.
Sensor Correct
+0°
(-180~+179
°)
Direction of motion sensor
is the same as cable gland.
System Setting 1
1 2 3 Menu
Positin Display :
Track :
Current Data :
Heading Indication :
Display Range Ring :
North Mark :
CSE. Data :
NAV. Data :
NMEA1 Baudrate :
NMEA2 Baudrate :
TVG Correction :
Units :
Temp Display :
Temp Graph :
TLL Output :
Ship's L/L Cursor L/L
Off On
Off Inbound Outbound
True Azimuth
Off On
Off On
Nav. Gyro
GPS Other
4800 9600 19200 38400
4800 9600 19200 38400
Off 1/2 1/1
m ft fm HR pb
°C °F
Off 20min 60min
Off On
Setup these menu
items.