Furun 406080A-FUR, Operator'S Manual

Page: 17 / 40

Chapter 2: Installation
9
2.2.2 Protective lid for the connector panel (406080A-
FUR AC/DC Power Supply Unit)
The connectors are protected by a
plastic lid. To access a connector
you have to remove the lid. To make
room for the connector cables you
must remove the U-shaped cutout
for the respective cable in the plastic
protective lid.
Removing the protective lid (406080A-FUR AC/DC Power
Supply Unit)
To connect the cables you
must remove the protective
lid.
To do this, unscrew the two
screws (M3x7mm” Torx-8) as
shown in the picture and put
the lid aside.
Inserting the cable in the Spring-loaded terminal connector
The connectors are spring-ter-
minal connectors. Use a suita-
ble tool to open the spring and
insert the cable in the opening
below.
Warning! Disconnect the AC power before removing the
protective lid. Hazardous voltage exists behind the
protective lid.