Furun 406080A-FUR, Operator'S Manual

Page: 19 / 40

Chapter 2: Installation
11
This connector is used when adding a 406080A-FUR AC/DC Power
Supply Unit (dual row spring loaded terminal).
3. In order to be able to daisy-chain up to three 406080A-FUR AC/DC
Power Supply Units the Mains AC connector has two terminals:
• Use one terminal for the incoming mains power.
• Use the other terminal for the mains power going to the next
406080A-FUR AC/DC Power Supply Unit.
DC output
The 406080A-FUR AC/DC Power Supply Unit supplies a DC output. To
connect the DC output
DC1 do as follows:
1. Connect the DC cable to the connector marked DC1 and the
equipment that must be powered.
AC input
To connect to additional
AC/DC Power Supply
DC 1
Connector type Spring-loaded terminal
Wire cross
section Up to 6 mm
2
Maximum load 30 A
+ DC out, plus
- DC out, minus
GND