TOUCHSCREEN INFRARED HEATER
INSTRUCTION & INSTALLATION MANUAL
Stand-by Mode
In any mode, by pressing the "Stand-by" button, the remote control will go into
stand-by mode and the device will stop operating.
By pressing this button again, the remote control will go back to the previous
mode.
Eco Mode
Eco mode can be activated to reduce power consumption when the room is
empty for a specific period of time. By pressing the "Eco" button, the remote
control display will show the icon of the function.
By pressing the "Eco" button again, the function will be disabled and the icon will
disappear.
“Window open” Mode
Pressing the "Eco" and "-" buttons simultaneously for 3 seconds will activate the
'window open' sensor. Pressing the "Eco" and "-" buttons again simultaneously for
3 seconds will disable the function. In this mode, if the heater detects a
temperature drop of more than 1ºC within a 5 minute period, the heater will switch
off for 30 minutes before reverting back to the previous settings
THE CARLILE INSTITUTE
HUDDERSFIELD ROAD
MELTHAM, HD9 4AE
2 : The “Night” mode temperature setting can not be higher than the “Comfort”
mode's one.
Example : If the “Comfort” mode's temperature has been set to 25 degrees, when
switching to “Night” mode and wanting to set the
temperature, once it reaches 25
degrees, the temperature will not rise, even when pressing the “Plus” button.
Antifreeze Mode ( see Fig.1 )
Go to “Antifreeze” mode, the temperature is fixed to 7 degrees, by pressing the
“Plus” or “Minus” buttons, the temperature cannot be neither risen nor reduced.
Clock Mode ( see Fig.1 )
Go to “Clock” mode, the LCD display will be showing temperature, date
, time and
state of the daily program.
Pilot-Wire Mode ( see Fig.1 )
Go to “Pilot
-
Wire” mode –
the device will recognise the commands received from
the Pilot-Wire (Comfort / Nigh / Antifreeze / ECO / Stand-by)
2-Hours Mode
In any mode, by pressing the “two hours” button, the device will start to heat up
the environment at full power for 2 hours.
By pressing the button again, the remote control will go back to the previous
mode.
(Fig 2)
Stand-by Mode
In any mode, by pressing the "Stand-by" button, the remote control will go into
stand-by mode and the device will stop operating.
By pressing this button again, the remote control will go back to the previous
mode. (Fig 3)