mbos8a_eng (13.03.2014)
- 20 -
Kompetent für Elektroniksysteme
mbos8a_eng (13.03.2014)
- 21 -
Kompetent für Elektroniksysteme
The
monitor status
can be programmed in
EEPROM register 026
as follows:
register 026
Monitor status after turning on
00 = monitor function is turned off
01 = special control function (WED) is turned on
02 = monitor function is turned on
The monitor status (
´00
`,´
01
`or
´02
`) can also be switched over while operating by
entering <
$A0><CR>, <$A1><CR>
or
<$A2><CR>.
Programming Mode EEPROM
To program an EEPROM register address <xxx> with the content <yy> proceed as
follows:
1) Start the service program (see section
service program
)
2) To check the value of a register Enter <
R
xxx>,<Return> on the terminal.
=> <>xxx: ww> appears on the screen.
3) Program the new register content <yy> (Hex value!!!) in the register
address <xxx> by entering the following on the terminal:
<Pxxx_yy>,<Return>(_=<
Space
>).
5) Check the new register content by means of the on-screen message:
<>xxx: ww
==>
yy >.
If instead of a valid address <xxx> the address <
999
> is entered, all registers are
programmed with the ex factory preset values. A list of all the EEPROM- addresses can
be found in the following section.
Please note (1):
Do not change any registers, which are not described in this manual or
whose functions are unclear or unknwon to you.
Please note (2):
Almost all adjustable values (e.g. times etc.) of the
Major BOS 4a
have
to be programmed as HEX numbers. See section
EEPROM-addresses
! A conversion
chart for HEX numbers can be found in the
attachment!
Summary of Contents for Major BOS 8a
Page 1: ...Major BOS 8a...
