ATR833 / P/N 833-(xxx)-(2xx)
Operation and Installation
17
Document-No.: 01.1403.010.71e / Revision: 3.01
When having the channel selection configured for 8.33 kHz steps (see
3.1), the frequency is input in three steps:
123.450
→
123.450
→
123.450
When having the channel selection configured for allowing 25 kHz
channels only (see 3.1), the frequency is input in two steps:
123.450
↔
123.450
2.5.3 Recall a Frequency from the User Memory
To access the user memory frequency list, press
MEM
once, and select
one of the 100 memory entries with the
turn knob.
The selected memory entry substitutes the former standby frequency.
In the lower row of the display, the number of the memory entry selected
is indicated by [MEM xx] (with xx = 00 … 99); if a name has been
provided by the user for this memory entry, it is displayed next to the
memory entry number.
ACT
123.450
SBY
121.270
MEM 17 HAMBURG
▲▼
interchanges the newly set standby frequency and the former active
frequency, and leaves the memory list menu.
If no input is done for 12 Seconds, the device returns to the standard
view, too.
In order to speed up the entering of new frequencies, it is
possible to configure the radio to allow entering of those
frequencies only that are used with 25 kHz channel width.
Please refer to chapter 3.1 for information on this
configuration.
However, when choosing this option, please keep in mind to
re-enable 8.33 kHz channel selection before flying into areas
where 8.33 kHz channels are used.
Entry number (Range: 00 – 99)
Summary of Contents for ATR833-OLED
Page 2: ......
