FULTON FT-0080C, Installation, Operation, Maintenance And Parts Manual

Page: 56 / 92

FT-C Vertical Electric Thermal Fluid Heater Manual 12 2013 ISSUE 1
Page 48
3
3.6.13
CHANGING SET POINT ON THE AzL
1) Hit Escape to Select Operation than hit Enter and scroll to Heater Set point, hit Enter to Set
point W1 hit Enter and enter new set point with Select buttons.
2) When accomplished hit Enter than Escape 3 times to Operational Stats hit Enter to Normal
Operation, hit Enter to get to the main screen.
3.6.14
FOR MANUAL OPERATION
1) Hit Escape and scroll to Manual, hit Enter to Auto / Manual / OFF , change to Manual and hit
escape to Set Load, change to 0 or desired load range with the select buttons.
2) When in Manual it will allow you to go to any load range to verify combustion.
3) When done hit Escape and scroll to Operational Stats, hit Enter to Normal Operation, hit Enter
to main screen.
4) To return back to Auto operation repeat step 1 & 2.
5) Please refer to this manual’s addendum for information on specific LMV 51 control
parameters.
Note: DO NOT leave unit unattended in Manual Operation, in this mode the LMV 51 will ignore its internal Set
Point.
3.7
REQUIRED PRESSURE DROP ACROSS THE HEATER
1. The thermal fluid pressure drop across your heater is critical. This should be recorded at the
completion of start-up. The pressure drop value is obtained by subtracting the heater outlet
pressure from the heater inlet pressure when the thermal fluid is at normal operating
temperature.
2. At the recommended standard flow rates, and 0.7 sp gr, the pressure drop across the heater
should be as shown in the chart in section 3.8.
3. In the event of an abnormal reading, contact the Fulton service department immediately. Failure
to take immediate action in the event of reduced fluid flow may result in rapid and serious
degradation of the fluid, with possible damage to the heater.