FULTON FT-0080C, Installation, Operation, Maintenance And Parts Manual

Page: 16 / 92

FT-C Vertical Electric Thermal Fluid Heater Manual 12 2013 ISSUE 1
Page 8
2
2.6.1
MINIMUM CLEARANCE FOR COIL REMOVAL
a) All heaters will also require a minimum clearance overhead for coil removal. In cases where
the available height is insufficient, a roof or ceiling trap might be considered.
b) Pipes should not be run within 250 mm of any control cabinets or combustible material.
c) Failure to provide suitable and safe access at the time of commissioning may cause delays, as
our Service Engineers are instructed not to commence commissioning if hazardous conditions
exist.
2.6
ACCESS
a) Access around the heater should be provided to facilitate maintenance. Appropriate clearances
for all sides follow.
b) Place heater with clearances to unprotected combustible materials, including plaster or
combustible supports, not less than the following:
MINIMUM CLEARANCE (m)
HEATER FRONT 1
HEATER SIDES 0.5
HEATER REAR 0.5
FLUE REAR
0.5
CLEARANCE (mm)
FT-0080C 2835
FT-0120C 3097
FT-0160C 3180
FT-0240C 3554
FT-0320C 4153
FT-0400C
4655
FT-0600C
6005
FT-0800C 6038
FT-1000C 6062
FT-1200C 6031
FT-1400C 6851
For minimum clearances for personnel access and burner removal, refer to Technical Information
sheet for the heater.