Step 20
Loosely attach a Foot to one of the Side Legs using four (4) Medium Machine
Screws. Once all screws are in place, tighten them completely, working in an X
pattern.
Repeat to attach the other Foot to the other Side Leg.
If you are planning to use Locking Casters with your Jarvis Desk, remove all five
Leveling Glides from the feet and thread the Braking Casters in their place at this
point.
I— Foot x2
V— Medium Machine
Screw x4
Double check that all of the screws on the desk are fully tightened.
Failure to install and tighten all screws may result in instability.
Step 21
Step 22
With a friend (or a few), lift the desk and gently flip it onto its Feet, supporting both
the top and the frame of the desk. Be careful to avoid the Handset.
If your desk sits unevenly on the floor, adjust the pre-installed leveling glides (or your
swapped-in Braking Casters) on the Feet as needed by threading them further in or
out.
Plug in the desk and proceed to Initial Calibration on the next step.
19
