Step 11
Slide the two (2) Center Rails into the Frame End (w/Capture Plate) you just attached
to the Desk Top. Orient the Rails so the cut-out slots face each other, and are on the
top side of the Center Rails, as shown.
Slide the Center Rail Support halfway down the Center Rails, covering the marks
in the middle of the Center Rails. The Center Rail Support does not need to be
screwed to the Desk Top—it will be locked to the Center Rails later.
Slide the Corner Leg Assembly onto the other end of the Center Rails.
Corner Leg Assembly
E— Center Rail Support x1
F— Center Rails x2
The Center Rail Support adds extra support for the
larger of the two tops. If you’re assembling your desk
in orientation A or D (see page 4), you will need to
add this in Step 13 instead.
If your largest top is smaller than 72”, you may leave
this part off.
Pro Tip
*Correct Center Rail
Orientation
12
