Full Boar FBBS-750, Instruction Manual

Page: 10 / 26

10
STAND ASSEMBLY
6. Assemble one of the short upper support and short lower
support pieces, ensuring it sits inside of both the leg &
long supports.
7. Once the nuts are hand tight, lift the frame up with only
the legs contacting the floor. One half of the frame is now
complete.
8. Repeat the exact process for the other side, which should
leave you with 2 identical halves. These halves can now
be joined together to complete the frame.
9.
Align the holes of each opposing member. If the holes are
misaligned and cannot be aligned by hand, use of a soft
hammer to ‘tap’ the members together is recommended.
Bolts and nuts can be inserted & tightened with hand
force only.
10. Then mount the stabilising legs and bar.
11. Once all of the members are joined together and all
fasteners are assembled, use a spanner to tension the
bolts.
12.
The rubber feet can now be attached to complete the
stand.
Note: Be sure not to over tighten the bolts as this can
damage the feet.
13.
Place the bandsaw on the stand and attached using the
large bolts nuts and washers.
x2