Full Boar FBBS-750, Instruction Manual

Page: 15 / 26

15
SAW ASSEMBLY
Assembling of saw table:
1.
Ensure the blade guard is raised out of the way prior to
fitting the saw table.
2. Remove the pin at the front of the table by opening
the groove in the saw table by levering and twisting
simultaneously, e.g. with a screwdriver.
3.
Slide the saw table onto it’s mount by aligning the blade
with the slot in the table.
4. Lower onto it’s mount and attach the knob to the screw
under the table. Secure the table by tightening the knob.
5.
Attach the tilt mounting plate and set the angle scale
pointer precisely. The table should read 0° when perfectly
flat. You can adjust the table support screw using a hex
key and a spanner and check the level using a spirt level.
6. Insert the pin at the front of the table so that it is flush
with the front surface. This may require tapping with a
soft hammer.
7.
Manually check that the blade runs freely and does not
touch the saw table.
8. Loosely fit the four bolts though the front of the table
with the nuts and washers fitted under the table and the
bolt heads sticking out the front.
9. Slide the rip fence ruler onto the bolts using the channels
in the rear of the rip fence ruler. The zero position can be
adjusted by shifting sideways. Tightening the bolts from
behind when the desired location is found to fix the rip
fence ruler in place.
10.
To disassemble, proceed in reverse order
WARNING!
Prior to assembly, ensure you switch the machine off and disconnect
it from the power supply.
!