-5-
2.1 Installation Requirements
In st al la ti on an d Wi ri ng
Chapter 2 Installation and Wiring
DZB100 Series
Chapter 2 provides the information needed to properly
and
the AC drive.
Make sure that the AC drive is wired according to the instructions contained in this chapter.
The instructions should be read and understood before the actual installation begins.
install
wire
2.1 Installation Requirements
2.2 Wiring
2.3 Basic Wiring Diagram
Install the AC drive vertically to provide proper ventilation. Adequate space isrequired between
the drive and a wall or other equipment. The figure below shows the minimum space needed.
All enclosures must provide adequate ventilation and the internal ambient temperature
must be kept at 40
or below.
A I R
A I R
RUN
STOP
JOG
FWD
REV
PRGM
RESET
DATA
FUNC
1.protected from rain or moisture;
2.protected from direct sunlight;
3.protected from corrosive gases or liquids;
4.free from airborne dust or metallic particles;
5.free from vibration;
6.free from magnetic noise
7.temperature: -10 C to +40 C; R.H.: 0% to 90%; air pressure: 86kPa to 106 kPa
Wiring orifice
Caution:
The AC drive should be installed in an environment that is:
