-17-
RUN
3.3 Digital Keypad Operating Modes & Programming steps
STOP
Di gi ta l K ey pa d O pe ra ti on
MODE
DZB100 Series
Pressing the
key after power on will cause the AC drive to operate at 60 Hz, which is the
factory default setting. Use the
key to halt operation. Refer to the Basic Wiring Diagram
in Chapter 2 for information on the wiring connection.
To change the o perating frequency, proceed as follows:
The operating frequency may be changed in either the STOP or
RUN
mode.
MODE
NOTES:
Display changes every time
or
key is pressed.
Increase the frequency
Decrease the frequency
