FULGOR FOBQ 1000 G MBK, Instructions For Installation And Use Manual

Page: 47 / 140

EN
11
Adapting to different types of gas
If the appliance is configured for a different type of gas than
that available, you have to replace the injectors with ones
corresponding to the type of gas to be used (see tables on
the preceding pages). The replacement will be made using
an adequate 7 mm key after having lowered the burners as
in the following images. After replacing the injector, regulate
the air to 1mm for natural gas and to the maximum if LPG.
To adjust the minimum, after lighting the burner, remove the
knob and the gasket below and rotate the screw of the tap
(B - see page 12), which should be totally closed for
LPG and opened about 3/4 turn for natural gas, keeping
in mind that a flame lower than 3 mm may not even be
“perceived” by the thermocouple of the tap. After regulating
the minimums, replace the gaskets and knobs.
1 - Unscrew the fixing screws of the burner.
BACK
FRONT
2 - Lower the burner and replace the injector.
FRONT
BACK