2 Installation
2 1 Regulation installation
and maintenance conditions
The appliance must be installed and the maintained by an
approved professional in accordance with the prevailing
regulations and code of practice, in particular:
The legislation on the handling of refrigerants.
2 2 Unpacking and reservations
2 2 1 Receipt
Carefully check, in the carrier’s presence, the general
appearance of the appliances and check that the
outdoor unit is not laid on its side or back.
In the case of any dispute, state any appropriate
reservations to the carrier in writing within 48 hours and
send a copy of this letter to the After-Sales service.
2 2 2 Handling
The outdoor unit should not be laid on its side or back
during transport.
Laying the unit down during transport is likely to damage
the internal tubes and the compressor suspensions.
Any damage caused by transportation of the unit lying
down is not covered by the warranty.
If necessary the outdoor unit may be tilted only during
manual handling (to go through a door or use a
staircase).
This operation must be conducted very carefully and
the appliance must be immediately restored to upright
position.
2 2 3 Accessories provided
-Accessories provided with the outdoor unit (
figure 10
).
-Accessories provided with the hydraulic unit
(
figure 9
)
2 3 Installation position
The choice of the position for installation is particularly
important insofar as any later movement is a delicate
operation requiring the intervention of a qualified
person.
Choose the site of the outdoor unit and the hydraulic
unit after discussion with the customer.
Observe the maximum and minimum distances
between the hydraulic unit and the outdoor unit
(
figure 17, page 16
) ; the guarantee of the performances
and the system’s service life depend on this.
2 4 Installation of the outdoor unit
2 4 1 Installation precautions
"
The outdoor unit must only be installed outside
(outdoors) If a shelter is required, it must have
broad openings on the 4 walls and observe the
installation clearances (
figure 11
)
• Choose a site that is preferably sunny and sheltered
from strong cold predominant winds (mistral,
tramontana, etc…).
• The unit must be easily accessible for future installation
and maintenance work.
• Ensure that it is possible to make the connections to
the hydraulic unit easily.
• The outdoor unit is able to withstand bad weather but
avoid installing in a position where it is likely to be
exposed to significant dirt or flowing water (under a
defective gutter for example).
5
Bracket
To secure the
hydraulic model
6
Outdoor sensor
To monitor the outdoor
temp
Figure 9 - Accessories provided
with the hydraulic unit
5
6
1
2
1
Elbow
For draining away the
condensates
2
Plug (x 2)
Figure 10 - Accessories provided
with the outdoor unit
Installation and operating manual "1364 - EN"
Heat pump split single service 3 phase
- 12 -
