System expansions
Installing and removing a board
34 - English
A26361-K547-Z400-1-7419
Installing board with clip
Ê
Open the workstation (see "Opening the workstation").
1
2
3
5
a
1
4
Ê
Push the edges of the clip together (1) and remove it (2).
Ê
Remove the cover plate from the slot (3).
!
Do not dispose of the cover plate. For cooling, protection against fire and in order to
comply with EMC regulations, you must refit the cover plate if you remove the board.
Ê
Take the new board out of its packaging.
Ê
Make the required settings for the board.
Ê
Push the board up to its slot (4).
Ensure that the end of a long board without angle bracket fits into the corresponding guide of
the workstation. Ensure also that the point of the angle bracket slots into guide (a).
Ê
Press the board into the slot so that it engages.
Ê
Replace the clip (5) which fixes the board. Make sure that the clip engages when released.
Ê
If necessary, connect the cables.
Ê
Close the system unit (see "Closing the Workstation").
i
If you have installed or removed a PCI board, please check the relevant PCI slot settings
in the
BIOS Setup
. If necessary, change the settings. Further information is provided in the
PCI board documentation.
