En-10
7. REMOTE CONTROLLER SETTING
Refer to the installation manual enclosed with the remote con-
trol unit when the wired remote control unit (option ) is used.
7.1. Load batteries (R03/LR03
×
2)
Press and slide the battery compartment lid on the reverse
(1)
side to open it. Slide in the direction of the arrow while
pressing the
mark.
Insert batteries.
(2)
Be sure to align the battery polarities (
＋
−
) correctly.
Close the battery compartment lid.
(3)
CAUTION
Take care to prevent infants from accidentally swallowing
•
batteries.
When not using the Remote Control Unit for an extended
•
period, remove the batteries to avoid possible leakage
and damage to the unit.
If leaking battery
fl
uid comes in contact with your skin,
•
eyes, or mouth, immediately wash with copious amounts
of water, and consult your physician.
Dead batteries should be removed immediately and dis-
•
posed of properly, either in a battery collection receptacle
or to the appropriate authority.
Do not attempt to recharge dry batteries.
•
NOTE
：
Never mix new and used batteries, or batteries of different
•
types.
Batteries should last about one year under normal use. If the
•
Remote Control Unit’s operating range becomes appreciably
reduced, replace the batteries and press the RESET button
with the tip of a ballpoint pen or other small object.
6.2.3. Wiring procedure
Remove the control box cover and install each connection
(1)
wire.
Screw
Control box cover
After wiring is complete, secure the remote controller
(2)
cable and transmission cable with the attached the binder
and the clamper.
Transmission cable
Wired remote controller
cable (option)
Wire clamper(accessory)
Bind securely
(a)
Detail(a)
Binder(accessory)
Cut of the excess
Transmission
cable
Wired remote
controller cable
(option)
Thread the binder through
the hole and tighten securely
Binder(accessory)
Cut of the excess
Wire clamper
(accessory)
Bind securely
Thread the binder
through the hole and
tighten securely
Install control box cover.
(3)
CAUTION
Do not bundle the remote controller cable, or wire the
•
remote controller cable in parallel, with the indoor unit
connection wire (to the outdoor unit) and the power sup-
ply cable. It may cause erroneous operation.
